Table of Contents
Advertisement
OPERATING INSTRUCTIONS: DRY VACUUMING
5. Insert the locking end of the hose into the vacuum port and turn to lock into place. Choose the
desired accessory and insert onto the end of the hose or extension wand (Fig. 5).
6. Verify that the switch is in the 'O' (OFF) position before plugging the power cord into the outlet
(Fig. 6 & 7). Hang the vacuum onto the rack or use off the rack.
7. Turn the motor on by flipping the on/off switch to the 'I' (ON) position and begin vacuuming (Fig.
8).
8. For remote control use, set the on/off switch to remote control position "
vacuum on by pressing the 'I' (ON) button on the remote control handle (Fig. 9 & 10).
9. Once you have completed vacuuming, press the on/off switch to the 'O' (OFF) position or press
the 'O' (OFF) button on the remote control for at least one second.
O = OFF
I = ON
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
LIQUID VACUUM OPERATION
1
2
LIQUID VACUUMING
WARNING:
ENTITLED "IMPORTANT SAFETY INSTRUCTIONS". DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR
GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST,
DO NOT VACUUM TOXIC MATERIALS.
WARNING:
PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
IMPORTANT! When vacuuming large volumes of liquids, we recommend that you remove the
vacuum from the wall mount rack and put it on the floor. The vacuum can be heavy when full of
liquids and may be difficult to remove from the rack.
1. Verify that the power cord is disconnected from the outlet. Make sure that the collection tank is
clean and free of dust and dirt (Fig. 1).
2. Remove the cartridge filter, then carefully install the foam wet filter over the filter cage and place
the power head back on the collection tank. For foam wet filter installation instructions, see
page 15 (Fig. 2).
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
= Remote Control
3
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
4
5
11
" and turn the
6
Advertisement
Table of Contents
