Table of Contents
Advertisement
OPERATING INSTRUCTIONS: WET VACUUMING
3. Push the required attachment onto the free end of the hose or extension wand (Fig. 3).
4. Ensure that the on/off switch is in the 'O' OFF position before plugging the power cord into the
outlet (Fig. 4 & 5).
5. Turn the motor on by flipping the switch on the power head to the 'I' ON position or flipping the
switch to the remote control position "
DO NOT SUBMERGE THE REMOTE CONTROL IN LIQUIDS.
6. After wet vacuuming, turn the machine off and remove plug from power supply. Empty the
collection tank, clean, and dry the inside and outside of the collection tank (Fig. 6). Remove the
foam wet filter and allow it to air dry before storage.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted
with a float valve that stops the suction action when the collection tank reaches its maximum
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and empty the liquid into a suitable receptacle or drain. To continue
vacuuming, refit the power head to the collection tank. After wet vacuuming, turn the machine off
and remove plug from power supply. To prevent the risk of possible mildew, empty the collection
tank, clean and dry the inside and outside of the collection tank. Remove the foam wet filter and
allow it to air dry before storage.
REMEMBER! The foam wet filter must be removed after wet vacuuming, and a cartridge filter
must be installed before dry vacuuming again.
" and use the 'I' ON button on the remote control.
12
Advertisement
Table of Contents
