Charging A Battery In The Camera - Canon EOS RP Instruction Manual

Charging a Battery in the Camera

Using USB Power Adapter PD-E1 (sold separately), you can charge Battery
Pack LP-E17 without removing it from the camera. Charging stops if you
operate the camera.
To protect batteries and keep them in optimal condition, do not charge
o
continuously for more than 24 hours.
In case of charging problems, the access lamp blinks in green and a protective
o
circuit stops charging. In this case, unplug the power cord, reattach the battery,
and wait a few minutes before plugging it in again. If the problem persists,
contact your dealer or nearest Canon Service Center.
558
1
Connect the USB power adapter.
2
Connect the power cord.
(1)
With the camera's power switch set to
z
< 2 >, insert the USB power adapter
plug fully into the digital terminal.
Connect the power cord to the USB
z
power adapter and plug the other end
into a power outlet.
Charging begins, and the access lamp
g
(1) is lit in green.
When charging is finished, the access
z
lamp turns off. Unplug the power cord
and disconnect the USB power adapter
from the camera.