ATEN ES0152 User Manual page 288

ES0152 / ES0152P CLI User Manual
COMMAND
ip ssh
show network-clock
clear network-clock clk-source <range_list>
network-clock clk-source <range_list>
nominate { clk-in | {interface <port_-
type_id>} }
no network-clock clk-source <range_list>
nominate
network-clock input-source { 1544khz |
2048khz | 10mhz }
no network-clock input-source
network-clock output-source { 1544khz |
2048khz | 10mhz }
no network-clock output-source
network-clock clk-source <range_list>
aneg-mode { master | slave | forced}
no network-clock clk-source <range_list>
aneg-mode
network-clock clk-source <range_list> hold-
timeout <3-18>
no network-clock clk-source <range_list>
hold-timeout
network-clock selector { { manual clk-
source <uint> } | selected | nonrevertive |
revertive | holdover | freerun }
no network-clock selector
network-clock clk-source <range_list> pri-
ority <0-1>
276
DESCRIPTION
Use the ip ssh global
configuration com-
mand to \
enable the
SSH. Use the no form
of this \
command to
disable the SSH.
Show selector state.
Clear active WTR
timer.
Nominate a clk input to
become a selectable
clock source.
Sets the station clock
input frequency
Sets the station clock
output frequency
Sets the preferred
negotiation.
The hold off timer
value in 100 ms.Valid
values are range 3-18.
Selection mode of
nominated clock
sources
Priority of nominated
clock sources.
P M
GLOBAL
15
_CONFIG
0 EXEC
15 EXEC
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG
GLOBAL
15
_CONFIG