User-Defined Character Setting Commands - SPRT SP-RMD11A User Manual

When the lowest dot n=1, select reverse print; when the lowest dot n=0, prohibit reverse
print.
Remark: Only the lowest dot of n is valid. Default n=1.
Notice: Reverse print not only support character mode but also support graphics mode
and Chinese character mode. When print the graphics in reverse direction, pay
attention to the printing sequence of graphic units, please check ESC K command.
ESC 6
Format: ASCII:
Decimal:
Hexadecimal::
Explanation:After inputting this command, all the characters will be printed out
according to the Characters Set 1 in ANK.
ESC 7
Format: ASCII:
Decimal:
Hexadecimal:
Explanation:After inputting this command, all the characters will be printed out
according to the Characters Set2 in ANK.

4.2.4 User-defined Character Setting Commands

ESC
＆
Format: ASCII:
Decimal:
Hexadecimal:
Explanation:This command permits user to define one character. Parameter m is
character code the user defines, m=32～255; parameter n1, n2......n6 is structure code to
define this character. The character dots should be 6x8, which means 6column and 8dots
each column. There is one character byte in each column and the MSB is on the tope as
below picture,
ESC 6
27 54
1B 36
ESC 7
27 55
1B 37
ESC m
＆
27 38 m
1B 26 m
Choose Characters Set 1
Choose Characters Set 2
User Define Character
n1 n2......n6
n1 n2......n6
n1 n2......n6
30