Maintenance Mode Cli Operation - VBrick Systems VBRICK APPLIANCE VB4000 Admin Manual

• If you log into the Integrated Web Server (IWS), the screen indicates the appliance is in
maintenance mode and the reason.
• The Telnet and/or Command Line Interface (CLI) prompt after you login is
VBMaintMode>
Code 10
Code 20
Code 30
Code 50
Code 60
Code FF

Maintenance Mode CLI Operation

After logging into Maintenance Mode as the Administrator, the
displayed and one or more of the following command sequences can be issued. Unlike
normal Integrated Web Server (IWS) and Command Line Interface (CLI) operations,
Maintenance Mode IWS and CLI does not automatically save and reboot when the network
parameters are changed. Purposely, in Maintenance Mode, after the user initiates changes and
applies, it is necessary to manually save and reboot.
Table 16. CLI Commands
Command
e 2
ex or exit
sv
rb
sd
sfd
c nt 5 x
c nt a
VBrick WM Appliance Admin Guide
and displays one of the following codes.
Operating system failed to load or the flash is corrupted.
Critical system files are missing or corrupted.
The Hardware Watchdog has failed.
Invalid Flash parameters found, defaults used.
Corrupted Bootline, default used.
Application failed to start up successfully either because of the
configuration or another problem. The VBrick appliance will enter
Maintenance Mode if the appliance does not boot properly on four
consecutive attempts.
Description
To start the editor mode. This
command must be entered prior to any
other command.
To leave the current menu level and
move up through the menu system.
To save the configuration
Reset the VBrick
Set the configuration parameters to
factory defaults, except the Ethernet
IP parameters
Set the configuration parameters to
factory defaults, including the Ethernet
IP parameters
To enable or disable DHCP
Apply the changes
Maintenance Mode
prompt is
VBMainMode>
Entry
e 1 - To display editor status.
Enter y (yes to save).
Enter y (yes to reset).
Confirmation is requested.
Confirmation is requested.
1 - Disable DHCP
2 - Enable DHCP
Must be issued prior to save.
129