Table of Contents
Advertisement
Current
Operational Mode
Configured
Operational Mode
Time Zone
Daylight Savings
Time
IR Enable
Fan Mode
SAP Timing
Method
RFC2974
Bandwidth
Relay Control
Front Panel LCD Display
These settings will be displayed for approximately 6 seconds. After 6 seconds the LCD will
display the current release, IP address, hostname, plus transmit and receive addresses and
other status information.
Box IP Address
Destination IP
Address
User String Enabled Enable or Disable the text displayed on the front panel LCD of the
Top Line User
String
Bottom Line User
String
Configuration: System > SNMP Traps
SNMP Traps are a subset of the SNMP management component of the VBrick. Use of any
element of the SNMP management system requires use of an SNMP browser or SNMP
VBrick WM Appliance Admin Guide
Indicates the current operational mode of the VBrick. The following
modes are supported. Note: Changing the Operational Mode
automatically reboots the VBrick.
Indicates the configured operational mode of the VBrick. The
following modes are supported:
• Run Mode – Normal operation.
• Diagnostics – User selected mode for running certain VBrick
diagnostics.
Select from list: (GMT-12) Eniwetok – (GMT +12) Auckland.
Enabled or Disabled.
Enable or Disable the IR remote control. This is the master enable and
disable for the IR across all functions.
This option allows a user to either force the fan always high or to
automatically cycle on and off based on measured temperature. Default
= Automatic.
Fixed or Variable - If fixed, the SAP timing will operate as defined in
the encoder, decoder and pump screens with fixed SAP transmission
and timeouts. If variable is selected, the entire VBrick will use SAP
timing as defined in RFC 2974. For most applications, Fixed Timing
should be used.
Allows setting the SAP bandwidth allocation in bits per second. This
setting is used only when the Timing Method is set to Variable.
This option allows forcing the relay connection to Open or Closed.
Enable or Disable the Box IP Address display on the Front Panel
Display.
Enable or Disable the Destination IP Address display on the Front
Panel Display.
VBrick appliance can be user defined.
The top line can support up to 16 characters. (characters in excess of
16 will scroll across the display for the bottom line).
The bottom line up to 40 characters.
WM Configuration
77
Advertisement
Table of Contents
