Table of Contents
Advertisement
Multicast
Transmit State
IP Bytes Transferred
IP Packets Sent
Status: Reflector Status
Status: Reflector Status > General
The Reflector Status page displays status based on the selected source. If you select
as the
Receiver
information; if you select
Push Receive
Push Receiver Status
Pull Receiver Status
Receiver Source IP
Bytes Received
Elapsed Time
Success Count
VBrick WM Appliance Admin Guide
Transmitting/Not Transmitting.
Total IP Bytes Transferred since last Reset.
Total IP Packets Sent since last Reset.
on the Configuration: Reflector page, you will see "push"
Reflector Source
, you see the corresponding "pull" information.
Pull Receiver
Indicates the current state of the reflector receiver.
means that the reflector is receiving a stream.
The address of the push source currently sending to this reflector.
Increments as data is successfully received.
The duration of the currently active push receiver connection.
Increments each time a push sender initiates a new connection with
this push receiver.
Status
Push
Started/Receiving
99
Advertisement
Table of Contents
