Diagnostics: Hard Drive - VBrick Systems VBRICK APPLIANCE VB4000 Admin Manual

Diagnostics: Hard Drive

Hard Drive Format
Check Disk
To run Check Disk:
1. Go to
Configuration: System > General
2. Set the
Configured Operational Mode
appliance will reboot. Wait until the front panel displays "Diagnostic Mode.")
3. Go to
Diagnostic: Hard Drive
4. Click to run the utility. (Note that the
Start
Mode.
5. Click
Refresh
6. When done, reset
VBrick WM Appliance Admin Guide
Use carefully. Removes all content and reformats the hard drive.
Runs the Check Disk utility. You must be in Diagnostic Mode to
start Check Disk. See below.
to
and click
to see the results.
Configured Operational Mode
.
. (After you press
Diagnostics
.
Begin Edit
button is only shown in Diagnostic
Start
to .
Run
Diagnostics
, the
Apply
117