Table of Contents
Advertisement
•
The Telnet and/or Command Line Interface (CLI) prompt after you login is
VBMaintMode>
Code 10
Code 20
Code 30
Code 50
Code 60
Code FF
Maintenance Mode CLI Operation
After logging into Maintenance Mode as the Administrator, the
displayed and one or more of the following command sequences can be issued from the
Command Line Interface. By design, in Maintenance Mode, after the user initiates changes
and applies, it is necessary to manually save and reboot. For more about the Command Line
Interface, see the Network Appliance Installation Guide.
To use CLI commands in Maintenance Mode
1. Make all desired changes, in any sequence, using the commands in Table 6.
2. When done type
3. Type
to save the configuration.
sv
Table 6. CLI Commands
Command
Description
To start the editor mode. This
e 2
command must be entered prior to
any other command.
To leave the current menu level and
ex or exit
move up through the menu system.
Reset the VBrick
rb
Set the configuration parameters to
sd
factory defaults, except the Ethernet
IP parameters
Set the configuration parameters to
sfd
factory defaults, including the
Ethernet IP parameters
To enable or disable DHCP
c nt 5 x
VBrick MPEG-2 Appliance Admin Guide
and displays one of t he following codes.
Operating system failed to load or the flash is corrupted.
Critical system files are missing or corrupted.
The Hardware Watchdog has failed.
Invalid Flash parameters found, defaults used.
Corrupted Bootline, default used.
Application failed to start up successfully either because of the
configuration or another problem. The VBrick appliance will enter
Maintenance Mode if the appliance does not boot properly on four
consecutive attempts.
to apply the changes.
c nt a
Maintenance Mode
prompt is
VBMainMode>
Entry
Type e 1 to display editor status.
Enter y (yes to reset).
Confirmation is requested.
Confirmation is requested.
1 – Disable DHCP
2 – Enable DHCP
97
Advertisement
Table of Contents
