VBrick Systems VBRICK APPLIANCE VB4000 Admin Manual page 53

Click here to play
RTSPU
HTTP URL
RTSPU URL
Select Video Rate
Select Audio Rate
Closed Caption and
Metadata
HTTP Estimated Bit
Rate for group 1
RTSP UDP Estimated
Bit Rate for group 1
HTTP URL for
group 1
RTSPU URL for
group 1
MBR Group2
MBR Group3
Client Timeout
Max. Allowed Clients Maximum number of players that can view video or audio from the
VBrick WM Appliance Admin Guide
Click to trigger Windows Media Player to initiate streaming via
RTSPU. Right-click and select
send to others for viewing.
Use this URL in a player, browser, or web page to view the stream
via HTTP.
Use this URL in a player or web page to view the stream via RTSPU.
Select a Video Rate for the selected group or None. Only those
Video Rates that are enabled on the Video page are selectable here.
Default = Video Rate1 for Group1; None for Group2 and Group3.
Select an Audio Rate for the selected group or none. Only those
Audio Rates that are enabled on the Audio page are selectable here.
Default = Audio Rate1 for Group1; None for Group2 and Group3.
Specifies whether script data is included in group. Script data
consists of Closed Caption and Meta Data depending on what is
enabled on the Video page. Default = disabled for all groups.
Read-only. Click
Refresh
change settings. It may take a few moments before new values are
displayed.
Read-only. Click
Refresh
change settings. It may take a few moments before new values are
displayed.
Read-only. Use this URL to force the Windows Media Player or
Windows Media Server to pull only the specified group.
http://172.22.173.10:8080/vbrickvideo1/group1
Read-only. Use this URL to force the Windows Media Player or
Windows Media Server to pull only the specified group.
rtspu://172.22.173.10/vbrickvideo1/group1
Check to enable group 2. Default = disabled.
Check to enable group 3. Default = disabled.
The number of seconds the VBrick will wait before it decides that a
player that was playing its video or audio is no longer viewing or
listening.
same VBrick at the same time using the RTSP or HTTP method.
Default = 50. This may be increased (maximum 200 clients) but
overall system performance may degrade as this number is increased.
It is recommended that if the Max Allowed Clients is increased, the
configuration should be tested to assure proper operation. To
disable HTTP and RTSP serving, set to zero.
to save the .asx and
Save Target As
to recalculate estimated bit rate when you
to recalculate estimated bit rate when you
WM Configuration
43