Lifting The Machine; Using The Quick-Release Tire Hubs - Toro MB-1600 Operator's Manual

Lifting the Machine

Hoist the machine using 3 lift points under the hopper.
Tilt the hopper forward to locate the 3 lift loops and
attach a chain or straps at each of the loops as shown
in Figure 9.
Note:
Take up the slack in the chain or straps to
properly balance the unit.
1. Lift points (3)
Lift the machine with a fork lift from the side or from
the front (Figure 10 and
the platform release ring
standing platform to allow access to the fork pockets.
Figure 10
1. Rear fork pockets
Figure 9
Figure 11). Pull out on
(Figure 12) and raise the
1. Side fork pockets
g019612
1. Platform release ring
Using the Quick-Release
Tire Hubs
The quick-release tire system allows quick removal of
the outer machine tires. The quick-release system
allows the machine to be converted from a 117 cm (46
inch) to a 91 cm (36 inch) wide machine without any
special tools for hub removal.
1. Position the inner wheel of the machine over a
2x4 and engage the parking brake.
2. Remove the large tee bolt in the center of the
wheel with a crow bar
g019610
16
Figure 11
Figure 12
(Figure 13).
g019611
g019606