Accessing The Media Server; Configuring Telnet For Windows 2000/Xp (If Necessary) - Avaya S8700 Series Manual

Accessing the media server

To access the media server:
1. Clear the ARP cache from the laptop if necessary. See
laptop on page 160 and return here.
2. Connect the laptop to the Services port (2) on the back of the media server using a
crossconnect cable.
3. Wait at least 3 minutes after powering up before starting a Telnet session to access the
information on the CD.

Configuring Telnet for Windows 2000/XP (if necessary)

The Microsoft Telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press Enter. The installation program sees this as 2 key presses. If running
Windows 2000/XP, you need to correct this before you copy the Remaster Program to the hard
drive.
To set up Telnet:
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type display and press Enter to see the current settings. If message says
Sending only CR
then close the dialog box.
If message says
Sending both CR & LF
then continue with step 4.
4. Type unset crlf and press Enter.
5. Type display and press Enter to verify that the settings changed. The message says
Sending only CR
6. Close the dialog box.
On first S8710 Media Server
Clearing the ARP cache on the
Issue 4 January 2005 171