Avaya S8700 Series Manual page 41

Terminal emulation may be used when connection to a media server command line interface
(CLI) or a SAT session is needed. Terminal emulation port settings:
9600 baud
No parity
8 data bits
1 stop bit
No flow control
S8700 or S8710
Disconnecting from the active media server
1. Unplug the laptop from the Services port on the back of the active media server.
Connecting to the standby media server
S8700 only
1. Connect to the Services port on the back of the standby media server.
2. Launch a Web browser.
3. Log in as craft or dadmin.
4. Click Launch Maintenance Web Pages.
5. Under Server, click Busy-out Server.
6. Click Busy Out.
S8700 or S8710
Disconnecting from the standby media server
1. Unplug the laptop from the Services port on the back of the standby media server.
Connecting to the active media server
Note:
If the PCMCIA memory card is currently plugged into the bottom slot on the
Note:
active media server, remove it. The MOST tool will be plugged into the bottom
slot.
1. Open a DOS Command window (Start > Run > Command)
Migrating translations
Issue 4 January 2005 41