Replacing The Circuit Pack; Assigning Ip Addresses To The Ipsi Circuit Pack; Upgrading The Ipsi Firmware (If Necessary) - Avaya S8700 Series Manual

Replacing the circuit pack

!
CAUTION:
When adding or replacing any hardware and associated cables and adapters, be
CAUTION:
sure to ground yourself against electrostatic discharge (ESD) by wearing a
grounded wrist strap.
Note:
To properly seat a circuit pack, push firmly on the front of the faceplate until the
Note:
latch reaches the bottom rail of the carrier. Then close the latch until it is fully
engaged.
To replace the circuit pack:
1. Remove the TN2312AP Internet Protocol Server Interface (IPSI) circuit pack from slot A02
and place it in an antistatic bag.
2. Insert the TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack into slot A02.

Assigning IP addresses to the IPSI circuit pack

For the IPSI circuit pack to get a static IP address, you must administer it directly through the
Ethernet port connection on the IPSI faceplate (top port). Go to
page 125 for specific information on how to do this.

Upgrading the IPSI firmware (if necessary)

You may need to upgrade the firmware on the IPSI(s). Each IPSI must be on the most current
and same firmware load. For the most current firmware load, go to the Avaya Support Web
page (http://avaya.com/support) and click Software and Firmware Downloads.
First verify the version of firmware currently on the IPSI circuit pack.
1. Under Installation and Upgrades, click View IPSI Version. Select Query All and click View
IPSI Version.
2. Verify the firmware release for the TN2312BP Internet Protocol Server Interface (IPSI-2).
Upgrade the firmware on the just installed TN2312BP Internet Protocol Server Interface (IPSI-2)
circuit pack if necessary. For information on how to do this, see "Upgrade the IPSI Firmware" in
the section titled "Upgrading Software and Firmware," which is part of the Documentation for
Avaya Communication Manager, Media Gateways and Servers (03-300151).
Upgrading a TN2312AP to a TN2312BP IP Server Interface circuit pack
Using static addressing
Issue 4 January 2005
on
195