Verifying Connectivity To The Network Server - Avaya S8700 Series Manual

Migrating from an S8700 Media Server to an S8710 Media Server

Verifying connectivity to the network server

To verify that the Ethernet port is working, ping from the media server the network server where
the backup files are stored.
Note:
You may need to restart your browser before doing the next steps.
Note:
1. Move the Ethernet cable connected to the customer's network from the shut down standby
S8700 Media Server to the S8710 Media Server (IP: Eth0; MC: Eth4). See
on the back of the S8710 Media Server
Figure 24: Port connections on the back of the S8710 Media Server
3
2
3
4
Figure notes:
1. Ethernet 0 - to control network A
(CNA) if dedicated control network
or to customer's network if
nondedicated control network
(straight-through CAT5 cable)
2. Ethernet 1 - to Services laptop
(cross-connect CAT5 cable)
3. Ethernet 2- to duplicated media
server (cross-connect CAT5 cable)
176 Migrating to the Avaya S8700 Media Server
3
100 MGz
2
100 MGz
1
133 MGz
VDCI
6
5
on page 176.
2
iLO
2 1
UID
4. Ethernet 3 - to control network B
(CNB) if duplicated control network
(used in Multi-Connect; not used in
IP-Connect)
5. Ethernet 4 - to customer's network
if dedicated control network
(straight-through CAT5 cable)
6. Not used
Port connections
1
cadsnet2 KLC 043004
1
2