Verifying Connectivity To Media Server; Upgrading Ipsi Firmware Version (If Necessary); Enabling Control Of Ipsis - Avaya S8710 Installing And Configuring

Verifying connectivity to media server

1
If not already open, open a browser and log in as craft.
2
Click Launch Maintenance Web Interface.
3
Under Diagnostics, click Ping and select Other server(s), All IPSIs, UPS(s), Ethernet switches
to verify connectivity to these units.
4
Click Execute Ping.
5
Verify that all endpoints respond correctly.

Upgrading IPSI firmware version (if necessary)

You may need to upgrade the firmware on some or all the IPSIs. All IPSIs must be on the same firmware
load.
1
Under IPSI Firmware Upgrades click IPSI Version.
2
Select Query All and click View IPSI Version.
3
Verify the firmware release for each TN2312BP IPSI. If an upgrade is required, follow the
procedures inUpgrading Software and Firmware—Avaya S8700 or S8710 Media Server (555-
245-115), Upgrading IPSI Firmware.

Enabling control of IPSIs

NOTE:
Make sure the IPSIs have the same, current firmware.
If a duplicated IPSIs, make sure that IPSI duplication is enabled before enabling IPSI
control. See
NOTE:
This procedure enables the IPSI circuit packs and allows them to control the port
networks.
Installing and Configuring the Avaya S8700 or S8710 Media Server
June 2004
Enabling IPSI duplication (duplicated control network only)
Connecting to the IPSIs
Verifying connectivity to media server
on page 47.
4
55