Install The Pressure And Tank Hoses - Raven AutoBoom Installation Manual

Chapter 3

Install the Pressure and Tank Hoses

Pressure and Tank Hoses Installed
FIGURE 4.
Locate and disconnect the pressure hose from port P of the machine's hydraulic valve.
1.
Connect the machine's pressure hose to the installed fitting in Port P of the AutoBoom valve.
2.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-392) in port P of the machine's
3.
hydraulic valve.
Note:
It may be necessary to install a 9/16" JIC M/F 90° swivel elbow fitting (P/N 333-0012-042) in the
machine's pressure port before installing the hydraulic hose.
Connect the 90° end of the installed hydraulic hose on the installed fitting in Port EF of the AutoBoom valve.
4.
Locate and disconnect the tank hose from port T of the machine's hydraulic valve.
5.
12
Hydraulics are under pressure. Care should
always be taken with a system that has been
pressurized. When disconnecting or purging
hydraulic hoses, be aware that the hydraulic
fluid within the machine's system may be
extremely hot and under high pressure.
When installing AutoBoom hydraulics or
performing diagnostics, maintenance, or routine
service, ensure precautions are taken to
prevent any foreign material or contaminants
from being introduced into the machine's
hydraulic system.
Objects or materials that are able to bypass the
machine's hydraulic filtration system will reduce
performance and possibly cause damage to the
AutoBoom hydraulic valve.
Sprayer Specialties XLRD Contour Series AutoBoom Installation Manual
WARNING
CAUTION
Pressure Hose
(Port P)
Tank Hose
(Left T Port)
Excess Flow
(Port EF)