Wiring; Wiring Connections; Install The Autoboom Node - Raven AutoBoom Installation Manual

Sprayer specialties xlrd contour series

Hide thumbs Also See for AutoBoom:

Table of Contents

CHAPTER

Note:

For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006)

generously on both the male and female ends of the connectors. Application of the grease will

prevent corrosion to the pins and wires.

AutoBoom Node Installed (Example Only)

FIGURE 1.

Mount the AutoBoom node (P/N 063-0130-013) to the valve mounting plate (P/N 107-0171-802) next to the

AutoBoom valve using three 3/8"-16 UNC x 1-1/4" zinc plated hex bolts (P/N 311-0054-106) and three

3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).

Manual No. 016-0230-089

W iring

C h a p t e r 5

CAUTION

Always connect the power cable as the last

step in the wiring process and verify that the

power leads are connected with the correct

polarity. Reversing power leads can cause

severe damage to the equipment.

Table of Contents