Chapter 2
Tools Needed
The following tools are recommended for installation of the AutoBoom system:
•
SAE standard-sized wrenches
•
Cable ties
•
Set of tools
Preparing for Installation
Before installing AutoBoom, park the machine on a level, clean, and dry surface. Leave the machine turned off
for the duration of the installation process.
During the installation process, follow good safety practices. Be sure to carefully read the instructions in this
manual as you complete the installation process.
Point of Reference
The instructions in this manual assume that you are standing behind the machine, looking toward the cab.
Hydraulic Fittings
This manual may reference the following types of hydraulic fittings:
•
SAE O-Ring fittings
•
ORFS (O-Ring Face Seal) fittings
•
JIC fittings
SAE O-ring fitting
4
ORFS fitting
Sprayer Specialties XLRD Contour Series AutoBoom Installation Manual
JIC fitting (M)