Table of Contents
Advertisement
Replacement routines
4.9
Replacing the SCSI backplane
Requirements
– The server has been switched off
– The power cables have been uplugged
– Rack model only: The server has been pulled out
– The housing cover has been removed
– The processor cover has been removed (see
Removing the SCSI backplane
Ê Unlock all hard disk modules and pull them forward a few centimeters.
Ê Remove any tape drives that are installed (or their module frame) from the
bays (see Options Guide).
Figure 16: Position of the cables on the SCSI backplane (view from the back)
Ê Unplug all cables from the SCSI backplane.
I
The cable plugs connected at the bottom of the SCSI backplane are
easier to access if you reach through the empty bay for the accessible
drives.
Service Supplement TX600 S3
Replacing the SCSI backplane
page
25)
35
Advertisement
Table of Contents
