Replacing The Control Panel Board - Fujitsu PRIMERGY TX600 S3 Service Supplement Manual

Replacing the control panel board

Replacement routines
4.7 Replacing the control panel board
Requirements
– The server has been switched off
– The power cables have been uplugged
– Rack model only: The server has been pulled out
– The housing cover has been removed
Ê Unplug all the cables from the control panel board.
A
Figure 14: Removing the control panel board (here: rack model)
Ê Undo the knurled screw (A) and remove the board.
To install the power backplane perform the above procedure in reverse.
32 Service Supplement TX600 S3