Table of Contents
Advertisement
Replacement routines
Replacing the control panel
4.6
Replacing the control panel
The control panel is held in its opening in the front panel with two metal clamps.
Requirements
– The server has been switched off
– The power cables have been uplugged
– Rack model only: The server has been pulled out
– The housing cover has been removed
Ê Unplug the cable at the back of the control panel.
A
A
1
Bild 13: Removing the control panel (here: rack model
)
Ê Press on the metal clamps (A) on both sides of the control panel and remove
it toward the front of the server.
To install the power backplane perform the above procedure in reverse.
1
In the floor-standing model the control panel is built in at a 90° angle.
Service Supplement TX600 S3
31
Advertisement
Table of Contents
