Fujitsu PRIMERGY TX600 S3 Service Supplement Manual page 30

Replacing the BMC board
Ê Carefully unplug the BMC board from its connector and lift it out (see (B) in
the figure).
Installing the BMC board
Figure 12: Installing the BMC board
Ê Position the BMC board as follows:
1. The pin (A) must be positioned over the hole provided in the system
board and
2. the contact strip of the BMC board must be positioned over the
corresponding strip on the system board (B).
Ê Carefully press the BMC board down so that it plugs into the system board.
I
After installing the new BMC board, you must update the firmware to
ensure correct operation.
Before you update the firmware, you must connect the jumper on the
bottom of the BMC board in such a way that overwriting is possible (see
chapter "Settings" on page
30
47f).
Service Supplement TX600 S3
Replacement routines