Replacing The System Board - Fujitsu PRIMERGY TX600 S3 Service Supplement Manual

Replacement routines
4.11

Replacing the system board

Requirements
– The server has been switched off
– The power cables have been uplugged
– Rack model only: The server has been pulled out
– The housing cover has been removed
– The memory boards or dummies have been removed (see Operating
Manual)
– The PCI boards have been removed (see Operating Manual)
– The external SCSI interface (if present) has been removed (see Options
Guide)
– The processors have been removed (see Options Guide)
– The VRM modules have been removed (see Options Guide)
Removing the system board
A
Figure 24: Removing the center brace
Ê Remove the center brace as follows:
– Slide both locking elements (A) to the unlocked position ("open lock"
symbol).
– Lift out the center brace (B).
Ê Remove the RoMB components (see
B
Service Supplement TX600 S3
Replacing the system board
page 40).
A
41