To Put Supports Below The Product - Husqvarna R 318X Workshop Manual

product become cool before you put the
product under the cover.
2. Make sure that the center of gravity of the product is
above the wheel axle of the transport vehicle. If a
trailer is used for transport, make sure that the down
force on your tow bar is correct.
3. Apply the parking brake.
4. If the product has Bluetooth, lock the product with
Husqvarna Connect.
5. Lower the cutting deck to the mow position.
6. Remove all loose objects.
7. Assemble the first strap through the rear
transmission frame. Refer to the illustration.
8. Tighten the strap rearward to attach the product to
the load area.
9. Put the second strap around the frame tunnel.
10. Attach the strap to the load area.
11. Tighten the strap in the direction of the front of the
load area to attach the product to the load area.
855 - 002 - 28.03.2019
12. Put the wheel blocks in front of and behind the rear
wheels.

2.9 To put supports below the product

WARNING: Always put supports on the 2 sides
of the product to make it stable.
1. Park the product on a hard and level ground.
2. Remove the cutting deck. Refer to
cutting deck on page 11 .
3. Lift the product with a jack assembly.
4. Put the front supports behind the front wheels.
5. Put the rear supports below the rear transmission
frame.
To remove the
Safety - 7