Husqvarna R 318X Workshop Manual page 49

9.5.14 Hydrostatic transmission cable
9.5.14.1 To remove the hydrostatic transmission cable
1. Remove the frame tunnel cover. Refer to
the covers on page 21 .
2. Loosen the cable locknut for the front hydrostatic
transmission ¼ turn.
3. Loosen the locking spring (A) and remove the
locking spring (B).
4. Remove the cable clamp for the front hydrostatic
transmission. The cable clamp is attached below the
frame tunnel cover.
5. Remove the transmission cover. Refer to
the covers on page 21 .
6. Remove the locking spring and the ball joint on the
rear hydrostatic transmission cable from the arm.
Remove the rear clamp.
7. Lift the front ball joint and pull out the cable.
8. Lift out the hydrostatic transmission cable and the
ball joint.
855 - 002 - 28.03.2019
To remove
A
B
To remove
9. Loosen the 2 ball joints from the hydrostatic
transmission cable.
10. Pull out the hydrostatic transmission cable.
9.5.14.2 To assemble the hydrostatic transmission cable
1. Attach the front link joint onto the new hydrostatic
transmission cable (A) and tighten the locknut (B).
A
2. Push the new cable through the frame in the same
routing as the used cable.
3. Push the cable sheath into the front bracket below
the frame tunnel cover.
4. Attach the front cable clamp for the hydrostatic
transmission.
5. Push the ball joint onto its bracket and attach the
locking spring.
B
Repair instructions - 49