Husqvarna R 318X Workshop Manual page 46

Note: A small quantity of oil can leak although the
transmission is drained.
1. Put support below the product. Refer to
supports below the product on page 7 .
2. Remove the rear wheels. Refer to
install the wheels on page 25 .
3. Drain the oil of the rear transmission. Refer to
Transmission maintenance on page 50 .
4. Remove the filter lid and pull out the filter. Replace
Technical data on page 66 .
the filter. Refer to
5. Make marks on the hydraulic hoses to make it easier
to connect them correctly when you assemble them.
6. Disconnect the hydraulic hoses from the rear
transmission.
7. Attach protective plugs in the transmission and the
hoses.
46 - Repair instructions
8. Loosen the hose from the transmission oil tank.
To put
To remove and
9. Loosen the cable and the speed control rod from the
10. Remove the clutch control. Refer to
11. Remove the transmission belt. Refer to
12. Remove the 5 screws that hold the rear transmission
Open the clamp for the suction pipe below the tank
and remove the hydraulic tank.
lever.
front transmission on page 45 .
the transmission belt on page 61 .
and lower the rear transmission.
To assemble the
To remove
855 - 002 - 28.03.2019