Download Print this page

Cutting System - Husqvarna R 318X Workshop Manual

Hide thumbs

Advertisement

4. Loosen the locknut (A) on the transmission
adjustment shaft.
5. Turn the adjustment shaft (B) clockwise until the
wheels start to turn rearward.
6. Make a mark at the position where the wheels start
to turn (C).
C
7. Turn the adjustment shaft (B) counterclockwise until
the wheels start to turn forward.
8. Make a mark at the position where the wheels start
to turn (D).
9. Turn the adjustment shaft (B) clockwise to the
middle position between the marks (E).
10. Hold the adjustment shaft (B) and tighten the locknut
(A).
52 - Repair instructions
A
B
B
E

9.6 Cutting system

9.6.1 To put the cutting deck in servicing position
1. See steps 1–8 in
page 11 .
2. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
3. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.
A
D
9.6.2 To put the cutting deck in mow position
1. Hold the front edge of the cutting deck with your left
hand.
2. Loosen the lock with your right hand.
3. Fold down the cutting deck and push it in until it
stops.
CAUTION: The drive belt can get caught
below the cutting deck. Pull on the drive belt
loop in the belt holder before you push the
cutting deck in.
To remove the cutting deck on
855 - 002 - 28.03.2019

Advertisement

loading

This manual is also suitable for:

R 316txR 320x awdR 316tx awdR 316tsx awdR 322tx awd