11. Move the cutting height lever (A) from the servicing
position.
A
12. Put the drive belt around the drive wheels. Make
sure that the drive belt is on the correct side of the
tension wheel.
13. Put the spring in the spring holder.
14. Attach the front cover.
4.8 To remove the cutting deck
1. Park the product on level ground and apply the
parking brake.
2. Set the cutting height lever in the servicing position.
855 - 002 - 28.03.2019
3. Push down the lift lever for the cutting deck to lower
the cutting deck.
4. Release the clip on the front cover with the tool
attached to the ignition key, and lift off the cover.
5. Pull the spring handle out from the spring holder to
loosen the drive belt tension.
6. Put the spring handle hook on the edge of the
equipment frame.
7. Remove the drive belt and put it in the belt holder.
Assembly - 11