To Do A Check Of The Parallelism Of The Cutting Deck; To Fill Fuel - Husqvarna R 318X Workshop Manual

8. Lift the cutting height stay and put it in the holder for
the cutting height stay.
9. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
10. Push the equipment frame (A) down. Lift the
equipment frame lock (B) to vertical position.
WARNING: The lock mechanism can cause
injury to fingers if you do not operate it
carefully. Put the equipment frame lock in
full vertical position. Hold the front edge of
the cutting deck with two hands when you
continue to the next step.
11. Pull the cutting deck out.
4.9 To do a check of the parallelism of the
cutting deck
1. Make sure that the air pressure in the tires is 60 kPa
(0.6 bar / 9.0 PSI).
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
12 - Assembly
A
B
5. Measure the distance between the ground and the
front and rear edges of the cutting deck. Make sure
that the rear edge is 4–6 mm (1/5") higher than the
front edge.

4.10 To fill fuel

WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
instructions on page 4 ).
WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result in
engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.
Special safety
855 - 002 - 28.03.2019