Husqvarna R 318X Workshop Manual page 56

9.6.8 Cutting deck belt overview
9.6.9 To replace the blades
1. Put the cutting deck in servicing position.
2. Lock the blade with a wooden block (A).
C
3. Loosen and remove the blade bolt (B), the washers
(C) and the blade (D).
4. Assemble the new blade with the ends that have an
angle in the direction of the cutting deck.
WARNING: Incorrect blade type can cause
objects to eject from the cutting deck and
cause serious injury. Use only the blades
given in Cutting deck, control points and
play on page 68 .
5. Attach the blade, the washer and the bolt. Tighten
the bolt with a torque of 45-50 Nm Nm.
9.6.10 To disassemble the blade bearings
1. Remove the covers on the cutting deck.
2. Remove the belts.
3. Remove the screws that hold the pulley. Lock the
blade with a wooden block.
56 - Repair instructions
B
D
A
4. Remove the pulley. Use a puller if it is necessary.
5. Loosen the 4 screws that hold the blade bearing and
remove the bearing assembly from the cutting deck.
6. Put the bearing housing in a vise and remove the
blade and washers.
855 - 002 - 28.03.2019