9.9.1 Belts overview
9.9.2 To lubricate the belt adjuster
The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
60 - Repair instructions
Engine pulley to transmission
Engine pulley to intermediate
Intermediate pulley to cutting
1. Remove the 2 screws that hold the belt shield and
lift it off.
2. Lubricate with a grease gun through the nipple at the
right side, below the lower belt pulley. Lubricate until
grease is pushed out of the rear side of the nipple.
3. Attach the belt shield and tighten the 2 screws.
855 - 002 - 28.03.2019