Husqvarna R 318X Workshop Manual page 10

4. Set the lift lever (B) for the cutting deck in mow
position.
A
5. Push the equipment frame down (A). Lift the
equipment frame lock (B) to vertical position.
WARNING: The lock mechanism can cause
injury to fingers if you do not operate it
carefully. Put the equipment frame lock in
full vertical position.
6. Put the drive belt as shown to make sure that it does
not get caught and break when the cutting deck is
attached.
10 - Assembly
B
A
B
7. Push the cutting deck into the equipment frame.
Make sure that the front guide plugs go in the
grooves on the equipment frame.
8. Push the cutting deck in until the rear guide plugs
touch the bottom of the grooves on the equipment
frame. The equipment frame lock releases
automatically.
9. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts.
10. Put the cutting height stay in the hole for the cutting
height stay.
855 - 002 - 28.03.2019