Led Indications - Unify Wireless Service Gateway WSG Installation Manual

Management
Mode button
Restart button
SD card slot
Rear side
LAN1
LAN2
V+ Ext/GND Ext External 12 V power supply to provide galvanic isolation of the inputs and out-
In1/In2 and
Out1/Out2
Error
12-24 V DC
100-240 V AC

LED Indications

The LEDs show different colors to determine type of information and have different flashing fre-
quency for showing the priority
.
Colors
Red
Yellow
Blue
A31003-M2000-J109-01-7631, 30/06/2020
Wireless Service Gateway WSG, Installation Guide
Mini-USB port for device management, see
Gateway WSG on page 22.
The Mode button is a momentary push button with a blue LED. Used for plac-
ing the module into specific modes by different push patterns.
The Restart button is a hole button that requires a paper clip (or similar) to be
able to push. Used for performing controlled restart and forced restart, see
Restarting the Wireless Service Gateway WSG
Currently not used (for future releases)
Modular jacks (RJ45) for connection of 10baseT or 100baseT Ethernet TCP/
IP network, see Ethernet Ports
Currently not used (for future releases)
puts, see below.
Connects AUX Inputs and
AUX Outputs, see Connection of AUX Inputs and AUX Outputs
22.
Connector where an error relay output is available, see
page 21.
Connection for external backup battery/power supply, see
page 19
Connection of supply voltage, see
Fault indication
Mode indication
Normal operation (OK)
Accessing Wireless Service
on page 37.
on page 21.
Supply Voltage on page 19
Description
LED Indications
on page
Error Relay Output on
Supply Voltage on
11