E Firmware - Circontrol Wallbox eNext User Manual

Wallbox eNext User Manual
Locks
The Locking mechanism secures the cable in the socket to prevent an undesired
disconnection of the vehicle and to protect the user from a possible electric shock.
This functionality is optional and may not be implemented in all the Charge Points
The diagnostic actuates over the locking mechanism of the socket opening and closing
it several times. An error will be notified in case the locking system movement is not
detected.
Heater
Heater is a set of devices that supplies heat to prevent devices malfunction due to
low temperature. This functionality is optional and may not be implemented in all the
Charge Points
The diagnostic will turn on the heater during several seconds and then turn it off. After
that, the heater should be warm.
E
28
Firmware
The Charge Point firmware can be upgraded
through 'HiCharger' app. There are two different
ways to perform the upgrade:
Automatic update: This option shall be carried
out with internet connection in the smartphone.
The 'HiCharger' App will check the Charge Point
firmware version and if any new firmware version
is available. If there is a new firmware version
available, a message with the new version code
will appear and requesting the user confirmation
to perform the installation.
Manual update: This option allows to perform the
firmware upgrade off-line in case internet is not
available near the Charge Point. Firmware can be
downloaded to the smartphone when internet is
available and later, when the Charge Point and
the smartphone are paired, the firmware can be
installed. For further information, please refer to
chapter "9 - 'HiCharger' App - Settings".