• This water line installation is not covered by the
Connecting Water to the
Unscrew the metal threaded collar nut at the
back of the appliance and place it over one end
of the water tube.
Firmly push the water tube onto the water inlet
valve and tighten up the collar nut.
Connecting to the Water Tap
This feature is only available on some models.
Push the water tube into the hole of the tap
connector supplied in the accessories. The pipe
should be held firmly whilst the connector is
pushed onto the pipe.
Ensure that the rubber washer is fitted to the
inside of the tap connector before screwing it
onto the tap.
• A separate connector or adaptor may need
to be purchased if your tap fitting does not
match the thread size of the connector
Checking the Water Connection
Turn on the water supply and switch on the
appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
Press and hold the Water Filter button for
three seconds. The new water filter has been
Place a cup under the water dispenser to verify
that water is flowing through the appliance.
Check the connecting tube and joints for leaks
Levelling and Door
When the appliance doors appear to be uneven,
follow the instructions below to align the doors.
• The spanner may differ depending on the model.
You will be provided with either spanner type A