Table of Contents
Advertisement
Access Control System
3.3.3.3
3.3.3.4
PPPoE
PPPoE (Point-to-Point Protocol over Ethernet) function is to access camera to
the internet by dialing the account provided by ISP (Telecom, Unicom and
CMCC).
Picture 3-24 PPPoE
1)
Select "Enable" to enable PPPoE function;
2)
Input user name and password provided by ISP;
3)
Click "Save" to validate setting. It will show dynamic IP after dialing
succeeds.
K-SNMP
Picture 3-25 K-SNMP
The camera supports KEDACOM private network management protocol.
Configuration steps are as follows:
1)
Input "Network Management Server IP Address" and "Device Location";
2)
Configure "CPU Utilization Threshold", "Memory Utilization Threshold"
and "Packet Loss Rate Threshold". The default values are all 100, ranging
1 ~ 100;
3)
Click "Save" to validate setting.
User Manual
Advertisement
Table of Contents
