Table of Contents
Advertisement
Access Control System
3. Web Client
3.1
Startup
For device installation and wiring, please referred to the Quick Start Guide.
After the device is installed, configure parameters and functions through the web client.
Please ensure the mutual network communication between the device and the PC before
configuring.
Note: User should be responsible for all risks of accessing the device to the Internet, including
but not limited to possible cyber-attack, hacking attack, virus infection and etc. This
company is not responsible for product failures and information disclosure caused
thereby, but will provide timely technical support for the device.
Requirements of PC for installing the client:
Processor: 3.3 GHz Intel CORE®i3 series and later version or other equivalent
processors
RAM Memory: 4GB or above
Operating System: Windows 7 or later
Browser: Suggest using Kernel browser, otherwise it will affect some functions of the
client
DirectX：9.0c
3.1.1
Activate
When the camera is first used, user should activate it and set the login password for
normal use. There are 3 methods to activate the device: though IPCSearch, through
browser and through device.
Activate through IPCSearch
1)
Get IPCSearch from our website and install it according to the prompts (address:
https://www.kedacom.com/cn/softtools/index.jhtml).
2)
After finishing installation, run IPCsearch and the system will search the cameras in
LAN and display the list as shown below.
User Manual
Advertisement
Table of Contents
