Note:
The hole diameter on the cement base of the expansion tube is 20 mm (0.79").
4. First insert a washer in the anchoring bolt followed by a nut.
5. Turn the nut until it is lowered in the bolt. Do not tighten at this time. All nuts must be inserted in
their respective anchoring bolts.
6. Repeat for the remaining anchoring bolts.
7. Once all nuts are inserted, tighten the anchoring bolts in an ascending order. See the following
figure.
Figure 36. Securing a Cabinet with Anchoring Bolts
Installation Manual
ON
OF F
STAN
DBY
RUN
FAU
LT
DC
DI SC
ON NE
CT
ON
OF F
AC
DI SC
ON NE
CT
ON
OF F
35
Installation