Rear Seedbox - Landoll Till ‘N Seed BPS6 Operator's Manual

Rear Seedbox

1. Adjust Seed Meter Setting.
2. Remove Seed Drive Disconnect Pin - Rear Box.
3. Prime Meters: Turn 5/8" Hex for Rear Box Calibration
CCW (Counter Clockwise) until all Meters are
discharging seed. Empty Calibration Trough or Tarp.
4. Turn the 5/8" Hex CCW 143 revolutions to meter out
5. Weigh the seed = Lbs / Acre.
6. Adjust Meters and Re-Calibrate as necessary.
7. Re-Install Seed Drive Disconnect Pin - Rear Box.
8. Re-Install Calibration Trough in Seeding Position.
Figure 2-11: Rear Seedbox Calibration
seed.
OPERATION
2-11