OPTIONAL EQUIPMENT INSTRUCTIONS
Do Not Pressure Clean With Air Or Water.
4. Press or slide Magnet Wheel onto Drive Shaft until it
is vertically centered with the Pick-up Switch.
5. Adjust the Pick-up Switch so the centerline of Magnet
Wheel and Pick-up Switch are horizontally and
vertically aligned with a maximum 1/8" gap between
them. Firmly tighten Switch to bracket and tighten set
screw (if present) in Wheel.
3-2
WARNING
Figure 3-2: Acre Meter (2 of 2)
Alignment of Pick-up Switch and Magnet Wheel is
critical. Improper alignment will cause the Acre Meter to
record acres erratically or not at all.
6. Route Pick-up Switch Cable up to the Acre Meter
Cable and connect mating plugs.
7. Securely fasten cable to frame using the adhesive
Cable Tie Mounting Base and Cable Ties to prevent
cable from becoming entangled or rubbing on moving
parts.
8. Program Acre Meter per the following instructions on
the next page.
3P091