Feedback Connection - gefran ADL300 Installations

Vector inverter for lifts with asynchronous/synchronous motors

Hide thumbs Also See for ADL300:

Table of Contents

4.3.2

Feedback Connection

This section describes the feedback connections for the ADL300B series.

For the ADL300A series, see

The names of the terminals and of the relative connection differs for the various card versions.

For more information see section

All terminal boards are extractable.

The indicated connection is not valid for ADL300B-...-AD1: in this model, the shield must be connected to the VGA connector shell.

Connections for the most common encoder types are shown below. For Technical data refer to ADL300 QS

manual section 7.2.3.

See the table on page 14 of ADL300 QS manual (code 1S9QSEN) to check which encoders can be

connected to your model ADL300B.

ADL300 - Fast installations and commissioning

Figure 4.3.3: Recommended card wiring

section A3 of the Appendix (ADL300 QS manual, code 1S9QSEN).

A3 of the Appendix (ADL300 QS manual, code 1S9QSEN).

Figure 4.3.4: Connection of shielding (recommended)

Pag. 20 of 52

Table of Contents

Show Quick Links

Table of Contents