Table of Contents
Advertisement
5
3
2
1
Record Mode
The NVS-31 MARK II's record engine allows you to record your program on the SD card. See
Appendix 2
for a list of recommended SD cards. The record parameters shown in the
diagram below will be discussed in detail in this section.
Note that after you've configured the record settings, click "Apply" to apply the new record
settings. Click "Start Record" to start recording and "Stop Record" to end recording. To
reset, simply click the default button.
Encoder Source
This option allows you to enable the record engine for configurations of various parameters.
If the recorder is not needed, disable this option.
File Name
Enter the name of your record file.
32
Advertisement
Table of Contents
Troubleshooting
