Datavideo KMU-200 Instruction Manual page 23

 Click START located at the bottom left corner of your screen.
 On the text bar, enter Network Connections then click the icon that appears.
 Double click the network adapter that connects your PC or laptop to the network.
 Click the "Properties" button.
 Select "Internet Protocol Version 4 (TCP/IPv4)" option and click the "Properties" button.
 Check the "Obtain an IP address automatically" option.
 Enter IPv4 settings:
-
IP Address: 192.168.1.2
-
Subnet Mask: 255.255.255.0 (System default is 255.255.255.0)
-
Default Gateway: Not required for one-to-one connection.
Note: Please write down the IPv4 address previously entered as it may be needed after
you are done with streaming or recording.
 The NVS-31 MARK II should now be connected with an IP address of 192.168.1.60.
If the NVS-31 MARK II still cannot connect, simply restore the NVS-31 MARK II to the
factory defaults.
-
Turn off the device.
-
Push the Record and Stream buttons simultaneously while turning on the device's
power.
-
Wait for about five seconds and release the button push as soon as you see the
RECORD and STREAM button LEDs light up.
-
Make sure no other devices are connected to the LAN (wired or wireless) because
this may result in IP conflicts.
23