Touch Screen; Preview; Program - Datavideo KMU-200 Instruction Manual

4. To enable the Program and Preview mode on the same channel, press the current
Preview Channel button.
Note: The Program and Preview modes can only be activated on one channel at a time.

4.2 Touch Screen

You can do a lot on the touch screen using simple gestures like zoom in on images, open
OSD menu and more.
Here are some common gestures:
Gesture Action
Tap: Tap the channel number to select PVW channel.
Two-finger scroll: Slide two fingers up to close the OSD menu or down to
open the OSD menu.
Two-finger Pinch to zoom: Pinch your thumb and finger open or close to
zoom in or out of the image.
Three-finger tap: Tap anywhere with three fingers to enable/disable PGM
channel only mode on the touch screen.

Preview

You are allowed to move the Preview Channel frame or non-Program Channel frames on the
touch screen. Simply tap and slide with one finger.

Program

In order to move the Program Channel frame, double tap to set program and preview to the
same channel.
To show only the Program Channel on the touch screen, tap the touch screen with three
fingers. To move the channel frame to the desired image crop, slide the frame with one
finger or tap the desired image point with one finger. Tap the touch panel again with three
fingers to exit the full screen mode.
You can also move the channel frame to the desired image point and at the same time to
allow the KMU-200 to change the channel frame size to a small or large frame. The steps are
outlined as follows:
1. Press the channel button to select the Program Channel.
18