System Booting And Functional Check (Digital Panel) - Doosan V158TI Operation & Maintenance Manual

3. Part Names, Operation and Settings
3.11 System Booting and Functional Check
- You can check whether the product is properly installed or not.
▶ Normal System Booting
1) Insert the key into the key switch and rotate it to the right (ON).
2) DOOSAN logo will appear for 17 seconds while the system is
booting (refer to the image).
※ If the logo does not appear after rotating the key,
Rotate it to the left (OFF) and then to the right (ON)

again
Check the harness connection at the back of the panel

Check whether the battery is discharged

3) The gauge display will appear after normal booting.
Gauge: check whether each gauge hand is within the

normal range and 'ERROR' or '-----' is displayed on the
screen.
※ Where 'ERROR' or '-----' is displayed on the screen
Check the harness connection

Function keys: check whether each function key is active

on the screen by pressing them.
Alarm: check whether the alarm is turned on.

Battery: check whether the battery voltage is 16V or

lower.
4) Where the initial gauge screen is normal, press START button
for 3 seconds to start the engine (the time can be reduced to 1
second. Refer to Digital Panel Manager).
5) Check whether the operation is in normal RPM (initial operation
in 400RPM or faster with the oil pressure of 1bar or higher) and
whether alarm is turned on.
[Fig. 3-28] DOOSAN Booting Logo
HY-DP-MANUAL-001
[Fig. 3-29] Gauge Display
22
Key On
[Fig. 3-27] Key Switch