Doosan V158TI Operation & Maintenance Manual page 237

Engine configuration procedure
Step 1) Press Menu button of the control-
ler and then you can see DRIVE
UNIT MENU.
Step 2) Select Engine Type by using Up
and Down buttons in DRIVE UNIT
MENU and then press Enter button.
Step 3) Go to Engine Type Menu and
select your engine type using Up
and Down buttons. Then, press
Enter button. At this moment, set-
ting values according to the
selected type of the engine are
designated and will be used as
information for the controller to
control the actuator.
(2) System setup configuration
Main setting items of the controller includes GEAR NUMBER, CRANKING RPM and SET RUN RPM.
You need to designate setting values to these items. Other system setup items are optional and there-
fore you can designate values for those items as necessary.
Configuring set run rpm
Step 1) Press Menu button of the controller and then you can see DRIVE UNIT MENU.
Step 2) Select System setup menu in DRIVE UNIT MENU using Up, Down, Left and Right buttons
and then press Enter button.
Step 3) Select SET RUN RPM in SYSTEM SETUP menu and then press Enter button.
Use Up and Down buttons to increase or decrease the normal operating speed of the engine
and then press Enter button.
Selection List by Engine Type
- 49 -
EDL11160022
EDL11160056
EDL11160057