Volvo Penta D4 Series Operator's Manual page 79

P0002655
47702599 12-2011
Compressor, checking oil
Checking and filling
1 Unscrew and lift up the oil dipstick. Dry the oil off.
Screw the oil dipstick down as far as it will go and
then unscrew and lift up.
2 Check that the oil level is between the MAX and
MIN marks. Check that the dip stick is screwed fully
home so that the reading is correct. If the dipstick
is not screwed fully home, the oil level will be above
the MIN mark even if the oil level is correct.
3 Fill with oil as required, use the dipstick hole. Oil
quantity and grade, see section Technical Data,
Lubrication System.
IMPORTANT!
The oil level shall be between the MAX and MIN marks
on the dipstick.
Compressor, oil change
1 Run the engine until it reaches normal operating
temperature.
2 Pull up the oil dipstick
3 Remove the plug and let the oil run out.
4 Replace the plug and fill with oil to the correct level.
Maintenance
77