Volvo Penta D4 Series Operator's Manual page 35

TRIM CRUISE
STATION
Assist CONTROL
LOW SINGLE
THROTTLE
SPEED LEVER
ONLY
P0002443
47702599 12-2011
Power Trim Assistant
The Power Trim Assistant, PTA, adjusts the trim angel
automatically according to engine speed (rpm). It is
possible to set five trim angles at five different engine
speeds, idle speed included. To set the angles, please
refer to PTA Calibration page 119.
Press the PTA button on the helm station panel or the
Trim Assist button on the control to activate or de-acti-
vate the function.
active.
P0013276
Trim Instruments
The engine must not be run with the drive in the "lift"
range.
Digital trim instrument
The trim instrument shows the drive trim setting. The
angle of the drive is given in relation to a horizontal line.
The lowest value indicates that the drive is fully trim-
med down and the highest value that the drive is fully
trimmed up. Note that the lowest value can vary from
boat to boat, depending on the angle of the transom.
2
When the drive angle is within the trim range, the
text "TRIM" is shown on the display.
1
When the drive angle is within the beach range, lamp
1 lights orange and the text "BEACH" is shown on the
display.
When the drive is in the lift range, the drive angle is
greater than +30° and lamp 2 lights red. There is no
text on the display.
Analog trim instrument
The trim instrument shows the drive trim setting. The
beach range is marked with an orange zone and the
lift range with a red zone.
is shown on the screen if the PTA function is
WARNING!
1 Trim ranges
2 Beach range (orange)
3 Lift range (red)
Instruments and Controls
33